Page 1 of 1
Tool needed
Posted: Wed Jul 02, 2008 8:19 pm
by 8b
Hello, I want to take off the saddle bag mounts and change them for the combo rear rack and saddle bag mounts I just purchased. The heads of the screws bolts are those star looking things I have seen on most BMW bikes. Can I use a tool I may have already, or do I need a special tool for these bolts so I dont scred them up trying to use the wrong tool. What do I need? Any one have tips or tricks for changing these over to the rear rack, and removing the saddle bag mounts?
Re: Tool needed
Posted: Wed Jul 02, 2008 8:25 pm
by deilenberger
ALL the bolts/screws on the R1200R are "TORX" screws. Do not try using any tools you have if you don't have Torx drivers - you will screw the bolts up.
Various types of Torx drivers are available at reasonable prices from places like Sears, Harbor Freight.. I own several sets of 3/8" drive "torx-drivers" - and some folding Torx sets I carry on the bike. I also have various collections of multi-bit tools that have Torx drivers included in the tools.
The right tool is the only tool to use.
Re: Tool needed
Posted: Wed Jul 02, 2008 8:38 pm
by 8b
Thanks Don, you are ALWAYS the man. I will dig out my BMW toolkits, I still have the full one from my F650CS, and the one that came with the R1200R. Is it likely that one or both of those BMW toolkits that came with the bikes would include the correct torx wrench?
Re: Tool needed
Posted: Thu Jul 03, 2008 4:00 am
by celticus
If you can't find one in your existing tool kits just go and buy one. You will need it for everything you do on this bike.
Mark
Re: Tool needed
Posted: Thu Jul 03, 2008 7:26 am
by AllanCook
I bought a really nice folding TORX set from Snap-On for $16. Fits everything on the bike. I have a few of the larger ones for my driver.
Re: Tool needed
Posted: Thu Jul 03, 2008 7:37 am
by Shortpower
I've had good luck finding the torx drivers I need at Autozone. Don't bother with going to NAPA. They almost never have the correct stuff.
Bill
Re: Tool needed
Posted: Thu Jul 03, 2008 3:38 pm
by BigEasy
deilenberger wrote:The right tool is the only tool to use.
More true words have never been spoken. The best way to screw up a job is to try to "make it work", DAMHIK, I've lived it both by my own hand and by contractors on jobs. Spend $20.00 and get a set, you'll thank yourself in the long run. Good luck on your project
Re: Tool needed
Posted: Thu Jul 03, 2008 4:27 pm
by mogu83
AllanCook wrote:I bought a really nice folding TORX set from Snap-On for $16. Fits everything on the bike. I have a few of the larger ones for my driver.
Allan - you actually bought something from a Snap-On guy for less than $20. Better check that something is in the box.
