Cross Country BMW in New Jersey
Posted: Fri May 26, 2006 11:40 pm
Question for you Jersey brethren -
I went by Cross Country BMW on Middlesex Ave near Edison last night to pick up a few bottles of synth. I noticed they also sell Ducs as well. Their showroom is a bit small - which isn't surprising given the cost of real estate in NJ, but they had a good assortment of bikes nonetheless. They had a nice K1200GT sitting out in the parking lot ready to be demo'd. Too bad I didn't have my gear with me...
Anyhoo, I'm going to be riding up to NJ on a regular basis this summer and was wondering how good this dealer is for service. My home dealer in Virginia is 90 miles away in Lynchburg, which is not on the way to any particular place unless I decide to take slower back roads to Richmond. So it's a bit of an inconvenience to get serviced there. If I get service in Edison (Exit 3 on I-287), it's not far from my clients in NJ/NYC. I could conceivably get work performed there on a Saturday before I head south back to VA.
If any of you have any experiences you can convey, please do so. Thanks in advance!
p.s. - they had a HP2 there as well. IMO, it looks cooler in photos than it does in person.
I went by Cross Country BMW on Middlesex Ave near Edison last night to pick up a few bottles of synth. I noticed they also sell Ducs as well. Their showroom is a bit small - which isn't surprising given the cost of real estate in NJ, but they had a good assortment of bikes nonetheless. They had a nice K1200GT sitting out in the parking lot ready to be demo'd. Too bad I didn't have my gear with me...
Anyhoo, I'm going to be riding up to NJ on a regular basis this summer and was wondering how good this dealer is for service. My home dealer in Virginia is 90 miles away in Lynchburg, which is not on the way to any particular place unless I decide to take slower back roads to Richmond. So it's a bit of an inconvenience to get serviced there. If I get service in Edison (Exit 3 on I-287), it's not far from my clients in NJ/NYC. I could conceivably get work performed there on a Saturday before I head south back to VA.
If any of you have any experiences you can convey, please do so. Thanks in advance!
p.s. - they had a HP2 there as well. IMO, it looks cooler in photos than it does in person.