Page 1 of 1
Pinning System Cases?
Posted: Mon Jan 09, 2006 8:24 pm
by frbank6
Does anyone know where the info is on doing this? Maybe the old board? There's a spot where you can drill and pin through the bottom mount to prevent them from falling off.
Posted: Mon Jan 09, 2006 11:35 pm
by NoRRmad
thanks
Posted: Tue Jan 10, 2006 9:04 am
by frbank6
Thank you! That was exactly what I was looking for.
pinning system cases
Posted: Sat Jan 14, 2006 10:45 am
by rocksterboy50
So where do you get those nice looking clamps that cyclerob uses? Sources and part numbers wouild be ideal but vague hints would get me started
Posted: Sat Jan 14, 2006 11:36 pm
by CycleRob
rocksterboy50,
There are 5 pics with imbedded text in that gallery you can clik on as an installation guide. Take the wheel off and follow the directions.
The pins are at Home Depot in one of the fastener isle's brown slide-out drawers - - - 2 to a bag and real cheap.
That modification, for it's low cost, huge security improvement, practicallity and simplicity is the one modification that I am most proud of.
Pinning..
Posted: Sun Jan 15, 2006 1:08 am
by larry
Why is it that you do this? I can't really tell from the photos what is being accomplished here.
Posted: Mon Jan 16, 2006 12:32 am
by CycleRob
larry,
They prevent the BMW system cases from falling off the bike if/when you forget to latch or lock them --or-- if the latch mechanism fails.
I lost my right side bag twice in 4 years- - - and it was returned only ONCE - - - by a Baptist Minister that removed it from the middle of the road. I was contacted by him using my checkbook info inside my lunchbox.
The clips are a very cheap insurance policy --and-- you can even YANK open the levers without having the bag pop off it's mounts.
Posted: Tue Jan 17, 2006 11:14 pm
by crousos
rocksterboy50, I got mine from Home Depot but I had to go to a couple of different ones to get them. I lost my left case last spring, not a good feeling. This was the best modification that I have done so far.
Thanks again CycleRob.
Tinos