easternbeaver.com

marecycling · Post by **marecycling** » Fri Jul 13, 2007 10:11 pm

Just wondering if any forum members may have already installed one of these relay kits on their bike? If so, were you satisfied with the kit and end result?

marecycling · Post by **marecycling** » Sun Jul 15, 2007 12:36 pm

Was hoping "Cycle Rob" or one of the other resident gearheads(thats a compliment!)might chime in on if this addition is relevent to wiring longevity if staying with stock bulb. Any info is appreciated.

Post by **DSKYZD** » Sun Jul 15, 2007 6:02 pm

It's not you, it the subject line. With all the happytime we've had posted lately I think they're afraid to open your thread. Seems you like had one in off-topic too. One of the other mods or Doug may have zapped it.

Edit your title and see if you get any better response.

DSKYZD

DG02 · Post by **DG02** » Sun Jul 15, 2007 9:59 pm

I installed one of the 4 fuse, 1 unswitched setups on my new F800ST to get around the canbus electrics. They're good quality components and the service was excellent.

Post by **rdsmith3** » Mon Jul 16, 2007 8:41 am

I have been using one of their relays for several years along with a 90/100 watt headlight bulb. It works great and is easy to connect. I do not have to worry about all that current draw going through the headlight switch because it is pulling right from the battery via much heavier gauge wiring and a direct connection. Using a relay is the best way to go for a headlight upgrade, and Eastern Beaver makes it easy to do.

(I have no connection with the company.)

Post by **TonyT607** » Mon Jul 16, 2007 8:43 pm

Two thumbs up for Jim Davis of Eastern Beaver. I ordered a fairly complex custom setup from him when I bought my R12ST in April 06. He did a great job and offered tips on installation. Top notch components and workmanship.

All done via email and diagrams.

My rig is a fused harness with relays that powers my PIAA's, GPS, XM Radio, and my ValentineOne. Jim also installed en extra set of leads for a future use. He uses Posilock and Posi-Seal connectors. All wired directly to the battery terminals (CAN BUS).

Post by **MikeCam** » Tue Jul 17, 2007 5:59 am

Eastern Beaver is a quality vendor using high grade parts and saving us DITY's hours of head banging. I recommend.

TX2Step · Post by **TX2Step** » Thu Jul 19, 2007 10:09 pm

I ordered a single H4 relay kit from him and installed it a few weeks ago. It arrived a week after I ordered it. It is made well and of high quality components. My stock 55/60 seems much brighter now.

I would not hesitate to order from Jim again.

mechanic savant · Post by **mechanic savant** » Fri Jul 20, 2007 6:31 am

Another eastern beaver supporter here ,I'm using the headlight relay kit w/good results & the 411 on the site regarding bulb heat ,etc. makes it a home run all vendors should bee this good ..are ya listening out there ??