BMW R1200R R1150R/T F800 K1200R R1100R/T R1250R RnineT Message Board

>Do you have access to a GS-911? No it, it's on the wish list. I might just need to buck up. I do have a DIY fault code reader that one can use to count the stored Motronic faults by reading pin 18. It's of limited use but a low cost option. I adjusted the cold start cable tension mechanism; increas...

I just worked through a surging issue and as a result I have - synced the throttle bodies, adjusted the valves, replaced the plugs (primary and secondary), replaced the O2 sensor, used fresh fuel, and FINALLY the fix was to replace the stick coils. No fault codes in the Motronic. Anyway I have this ...

I have 2004 r1150r 15k on it. The starter whine just started; was 'normal' and now it's got the noise. To me this sounds like the starter its not promptly disengaging. You Tube vid for your viewing pleasure. http://youtu.be/-3HiNuWUF8c I browsed a few posts and it was recommended that I check the al...

Nice setup. Do you ever take them off or do you just leave them on there? Any pics of the build process? The rack is mounted to the two factory hardpoints on each side of the bike. There is a cross brace connecting the racks by the license plate. The entire rack assembly (cases attached) removes in...

I home fabricated some mounts out of 3/8 square steel tube. Attached are 1550 Pelican boxes. They have been on the bike two years with no issues. http://home.comcast.net/~crnord//pwpimages/.__480_360_140-4051_IMG.JPG http://home.comcast.net/~crnord//pwpimages/.__480_360_140-4053_IMG.JPG http://home....

>Can tank dents be removed? Any experience here? I removed a bunch of tank dents from a Honda (CB550K 76') that I had years ago.; back in the days when I had lots of time. Anyway, I removed (washed!!) all the fuel from the tank and attached the tank to an air compressor via the fuel drain. Pressuriz...